Wholesale WPC Wood Doors Factory Introduces The Use Details Of
-
Wholesale WPC wood Doors Factory introduces the installation method of glass doors:
1. Before installing the glass door, check whether the door and window sashes are flat and whether the reserved holes are thorough and rough. If they are not suitable for the needs, they should be revised first.
2. The steel frame and door leaf glass of the device should be fixed by steel wire clips. The partition should not be larger than 300 sisters, and there are more than two on each side. It is also possible to put a putty surface layer on the steel wire clips to increase the tightness.
3. If fixed with putty, the putty should be filled and polished. If a rubber pad is used, the rubber pad should be embedded first, and the pressure strip and the screw should be used to stand still.
4. If the pressing strip is static, usually press the strip on the four sides or both ends and seal it with sealant.
5. Install various fundraising materials to be suitable for attempts to reduce the relevant standards and regulations.
6. When assembling stained glass and regional flower glass, it should be consistent with the planning, and there should be no misalignment, oblique bending or looseness. The orientation of the glass should be suitable for planning requirements.
Through the above introduction, WPC Glass Doors Factory hopes that you can simply refer to the content of this article in future use.